Although small in size, great in capabilities. The Digispark ATTINY85 Mini USB Development Board is similar to the Arduino but cheaper and smaller (of course a bit less powerful). With a whole host of shields to extend its functionality and the ability to use the familiar Arduino IDE, this board is a great way to jump into microcontroller electronics.
Complete USB Development Board Cheap Enough to Leave in a Project. If you have never heard of the Digispark ATtiny board before, it may take you more than a moment to understand its full power and potential. So read this carefully:
Firstly, it’s a 20MHz, AVR 8-bit microcontroller with 8 KB flash, 512 bytes of RAM
You get up to 5 GPIOs, 4 ADCs, 2 PWMs, 1 SPI, and 1 I2C[*]
Secondly, it’s fully compatible with Arduino
Thirdly, it can be directly programmed via USB without needing any other programmer!
And finally, it is available at a cheap price!!
The Digispark is shipped fully assembled except for the two included and easy to solder headers.
3D Printed Robotic Prosthetic Hand
4x4 Matrix Keypad Membrane Switch Arduino, Arm and Other MCU (Pack of 1) AB0100
PL2303 PL2303HX USB To TTL(Serial) Converter Module – 5 Pin AB0173
Resistors, 10K ohm, 1/4 Watt, 1% Tolerance, 100Pieces
Wireless Hand Gesture Control Car Diy Project For Science/Engineering Student's
MEGA R3 Board ATmega 2560 + USB Cable Compatible with Arduino IDE Projects AB0130 









